Register Log in. Custom Search. View previous topic :: View next topic. Posted: Sat Dec 01, am Post subject: esky a transmitter. I screwed up my Belt cp right out of the box. I was spinning it up and accidently hit the left toggle which the book says is for inverted flight.
|Published (Last):||19 March 2019|
|PDF File Size:||15.54 Mb|
|ePub File Size:||14.13 Mb|
|Price:||Free* [*Free Regsitration Required]|
Forgot Password? Today's Posts. Mark Forums Read. Honey Bee King 3 2. Thread Tools. Search this Thread. I think I may have messes up the transmitter somehow by messing with the switches both outer and inner trying to get it to work with EFlight. Since then I have purchased a "Blade mcpx" mini help to train on. I have actually be getting fairly comfortable and decide to have another crack at my King 3, However I realised that my Esky ET61 transmitter was set to mode one instead of mode 2 blade is mode 2.
So I followed the directions to every step and didn't achieve the result that I was after. It seems that my throttle is on the right stick which if I were in mode 2 should be on the left.
However when I Throttle all the way up on the right stick the heli blades spin at full speed but it won't lift, But if I also Push the left stick up this should be "elevator" the Heli will lift off straight up! Reply Like. View Public Profile. Send a private message to Blueflamman. Find More Posts by Blueflamman.
View iTrader Profile. RE: Honey Bee King 3 2. First of all make sure you have plugged all the servo plugs right to the receiver. Download the manual for your model and check. Not a newer model, just the one you own.
It must have some variations of the 6ch transmitter. You must already know but just in case to remind you to be careful with the spinning rotor. Send a private message to aircrash. Find More Posts by aircrash. Hi there and thanks for taking the time to reply, I managed to find the exact TX manual for my Esky ET61 but no mention on how to change it to mode to.
So far I have contacted esky direct and am awaiting a reply to my question of what the internal switches do to affect the TX see last pic on the above link but still awaiting a reply. As far as the servos plugged into the RX, everything looks fine. I even took them off one at a time and put them back. I'm also wondering if their is an app for mac or windows that will let me plug my TX in to check what controls are affecting which channel and cross check this with the config of the heli?
Could anybody recommend a program. I actually remember plugging my TX into real flight about a year ago but it wouldn't work as the control setting were mixed up. For example - When I pushed the left stick up it would move more than 1 channel. Is it possible that I inadvertently messes up something with the TX?
S- Also noticed that Esky sell a mode 2 version of my Tx. Reply Subscribe. Back to Subforum. View Next Unread. Posting Rules. You may not post new threads. BB code is On. Smilies are On. Forum Rules. Show Printable Version. Email this Page. Search this Thread : Advanced Search. Thread Tools Show Printable Version. Advanced Search. Close X.
ESky 0406A Tx, 0420A and 0704 Gyro Guide:
Honey Bee King 3 2.4GHz - Esky Et61 transmitter problems
About me Home. The reverse switch should be switched to REV. The gain can be adjusted to correct movements of the tail. THe red indicator light will flicker when the helicopter is first connected, then go to solid red when the calibration process is complete. You just conect the PPM signal out to the pin 4 of arduino and arduino ground with the ground of the device. So I thought a post on what everything on the transmitter does was in order.